At that point the lid light makes a clicking noise.
Whirlpool cabrio washer lid lock override.
Next open the lid and insert a screwdriver into the lid switch actuator hole.
When you close the lid the object goes into the hole and presses a lever or button.
If you leave the lid.
If it still won t budge proceed to plan b.
Step 4 put the lid back down and plug the washing machine back into the electrical outlet.
There should be an object on the edge of the lid and a hole on the edge of the opening.
Let the washer sit unplugged for about 10 minutes then try lifting the lid.
Ask your own appliance question.
Under operation start with the new switch in the off position then start the machine wash cycle as you would normally do wait a couple of seconds and then hit new switch so that it is in the on position.
Place a magnet between the two so there is a magnetic connection between the lid lock and the solenoid inside the washer.
Connect the blue and white wires start a load and wait until the lid lock red light comes on.
Most washing machines come equipped with a lid switch.
This is one of the most common problems with direct drive washing machines.
You will need to take a look at the lid lock assembly and see if there is a visible issue with it possible electrical issue or possibly something else may be causing the issue.
If the lid will not lock and keeps clicking on your whirlpool cabrio washer it is probably a faulty lock switch assembly.
If it opens you re all set.
The lid lock mechanisms on some washers are heat activated which means overriding them is as simple as letting them cool off.
Look for the lid lock switch on the underside of the top panel and where it fits into the appliance.
If your whirlpool cabrio washer will fill with water but won t spin the lid lock switch is probably bad.
To diagnose this problem you ll want to put the washer in a spin mode.
Then connect the red wire to the blue and white wires and wash cycle should begin.
