6 replace all parts and panels before operating.
Whirlpool hall effect sensor.
5 check the hall sensor by removing the control board p7 connector and testing for 5 vdc between p7 7 and p7 1.
So for giggles i checked the output of the hall sensor to the board while running and it was barely 1 volt dc.
8 start a cook cycle and check for proper operation.
If test is good go to step 6.
Check the hall sensor by removing the control board p7 connector and testing for 5 vdc between p7 7 and p7 1.
Cooling fan speed too low fan speed below 500 rpm either because the fan is spinning too slowly or because there is a problem with the hall effect sensor.
If test is good go to step 6.
Start a cook cycle and check for proper operation.
Pull the range forward and remove the top access cover.
8 start a cook cycle and check for proper operation.
Whirlpool brands include whirlpool maytag kitchenaid jenn air amana magic chef admiral norge roper and others.
The whirlpool oven sensor protrudes from the rear wall of the oven and connects to the oven thermostat.
It helps the control board make sure that everything is running as it should.
Verify there are no obstructions in the blower.
Manufactured by whirlpool oem.
Finally figuring out a way to test the hall sensors without taking the motor apart.
The hall sensor also known as the rotor position sensor rps is part of the automated system of your washing machine.
6 replace all parts and panels before operating.
Plug in range or reconnect power.
7 plug in range or reconnect power.
Does the hall effect sensor included on the speed control assembly.
Manufacturer part w11107275.
5 check the hall sensor by removing the control board p7 connector and testing for 5 vdc between p7 7 and p7 1.
This is a new genuine whirlpool replacement part.
So far so good.
Unplug range or disconnect power.
Part number pd00037690.
I checked the output to the hall effect sensor at the board which you need to have the oven plugged in and running to do this test contrary to the code sheet troubleshooting instructions and it was 5v dc.
3 people found this helpful.
If test results are not correct replace the hall sensor.
Top rated repair story eric from nc.
As the element heats the sensor senses the ambient temperature inside the oven.
Range oven blower motor with hall sensor.
If test results are not correct replace the hall sensor.
If test is good go to step 6.
Basically the hall sensor keeps an eye on the washer s motor to ensure it is working correctly and at the correct time during your washing cycle.
If test results are not correct replace the hall sensor.
